Error code list for Constructa cooker & stove

E05-32
Cause:
Button error.
Solution:
The error code typically appears if the button has been held down for too long or if the button has become stuck. Release the button.
E05-11
Cause:
Air in the systems.
Solution:
1. Confirm error with the ON/OFF button (if E511 still appears in the display)2. Switch on the device3. Select top/bottom heat at 80 °C and add steam4. End process after approximately 5-10 min5. Choose steam at 100 °C or reheat at 120 °C (depending on the appliance)6. Finish again after approximately 5-10 minIf E511 occurs again, the process is repeated one more time.
E010D
Cause:
Communication error.
Solution:
The error code is typically resolved by disconnecting the oven from the power supply for 30 minutes and reconnecting it afterwards. If this does not solve your problem, we recommend that you search for symptoms via our troubleshooting guide instead.
E106
Cause:
Door not locked during self cleaning.
Solution:
Replace the door lock.
ER0
Cause:
Communication error.
Solution:
The error code is typically resolved by disconnecting the oven from the power supply for 30 minutes and reconnecting it afterwards. If this does not solve your problem, we recommend that you search for symptoms via our troubleshooting guide instead.
ER1
Cause:
PT5000 temperature sensor error.
Solution:
Replace the thermostat.
Thermostat
ER2
Cause:
Power connection error.
Solution:
Check that the mains cable is inserted correctly into the socket. Also check the mains cable for defects.
ER3
Cause:
Overheating detected.
Solution:
Replace the cooling fan.
ER4
Cause:
PT5000 temperature sensor error.
Solution:
Replace the thermostat.
Thermostat
ER6
Cause:
Door is open.
Solution:
Replace the door lock.
ER7
Cause:
Door is open.
Solution:
Replace the door lock.
ER9
Cause:
Power failure detected.
Solution:
The error code should disappear when the oven is reconnected to power. If it doesn't, try unplugging it for 30 minutes and plugging it back in. If this does not correct the problem, it is possible that the error is caused by a faulty control module.
ER11
Cause:
Button error.
Solution:
The error code typically appears if the button has been held down for too long or if the button has become stuck. Release the button.
ER15
Cause:
Temperature too high.
Solution:
The error code appears when the detected temperature reaches more than 380°C. This is usually because the pyrolysis program has started, and when this is over and the oven has cooled down, the error code should disappear again.

Cookie information

Error code list for Constructa cooker & stove

E05-32

Cause:

Solution:

E05-11

Cause:

Solution:

E010D

Cause:

Solution:

E106

Cause:

Solution:

ER0

Cause:

Solution:

ER1

Cause:

Solution:

ER2

Cause:

Solution:

ER3

Cause:

Solution:

ER4

Cause:

Solution:

ER6

Cause:

Solution:

ER7

Cause:

Solution:

ER9

Cause:

Solution:

ER11

Cause:

Solution:

ER15

Cause:

Solution: